Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

intake manifold By Steve Gray - 07/01/2003 9:11:43 AM; IP 206.227.160.12 I have a 1966 390 2v/c6 that I am rebuilding. I had picked up a performer 390 at a swap meet and was ready to install it when I noticed how large the difference was in port size between the heads and the intake. Is this normal? Also is it common to throw away the cork gaskets and seal the ends with silicone on fe's as it is on SBC,s. There is a pin at the front of the block that alines the stock intake but the performer is not drilled for this pin. Do I remove the pin?

This thread, so far...

Skip Navigation Links. intake manifold -- Steve Gray, 07/01/2003  RE: Yep, maybe, yep. -- Gerry Proctor, 07/01/2003  I'm thinking you're lucky. -- Dave Shoe, 07/01/2003

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024215537 in the box