|
|
|
|
Original Message
|
| RE: installing a camshaft, and etc. |
| By Barry B - 07/09/2003 1:29:15 PM; IP 134.217.237.30 |
Don't try to match those heads to that intake, just run it as it is. The big mismatch is on the floor of the port, the heads have a raised floor. If you try to lower the floor, you'll hit water right away. If you must grind, just do the top and sides but I don't think it will buy you much. You might want to dry-fit the manifold without gaskets first to see if it has been cut and how big the gaps are.
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|