|
|
|
|
Original Message
|
| lifter and pushrod problem |
| By Boyd - 07/26/2003 6:29:36 PM; IP 152.163.252.162 |
| I've got a 410 Merc with Edelbrock Performer RPM cam and lifters, H/S roller rockers, and Crane 3/8 pushrods. The rockers were sliding off of the valves on a couple of cylinders. I assumed the springs were worn so I bought some solid spacers from Dove. After I installed them I noticed that some of the pushrods were rubbing on the intake which is also Edelbrock Performer RPM. Today I pulled the intake off to ream out the holes and noticed that the pushrods were not sitting in the lifters quite right. The keepers had come off of two of the lifters so I'm going to replace the lifters. Just wondering if I should buy the lifters that match my pushrods or change the lifters and the pushrods to 5/16. Is anyone running aything similar to this setup? Any help is appreciated |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|