|
|
|
|
Original Message
|
| RE: erson rockers-bolt hole alignment? |
| By Monty - 07/31/2003 10:27:15 AM; IP 198.125.177.159 |
| The shafts on the Erson rockers are free to spin on the shaft supports. If the holes do not line up, which is common, you use a screwdriver to manually align these. Do not worry about whether the oil holes face up or down since on the Erson assembly it does not matter. If you use Edelbrock heads you will have to get a shim kit from Erson to relocate the rockers to align to some of the valve stems. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|