|
|
|
|
Original Message
|
| RE: bent pushrod and seized valve in rebuild |
| By giacamo - 11/05/2003 7:44:22 PM; IP 63.163.157.93 |
| problie valve gide to tight to start with. or if its a exaust valve you haft to make shure the gide douse not extend into the port the exaust gass will heat it up and cause the exposed gide aeria to sease on the valve. thay needto be trimed flush with casting. i,v sean this befor......... |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|