|
|
|
|
Original Message
|
| RE: 390/410 oiling questions |
| By Dan Javaras - 11/17/2003 9:18:49 PM; IP 64.12.96.38 |
| Paul....Assuming your 390 is drilled for hydraulic lifters, you need to ensure that you keep the center oil gallery open and feeding your cam bearings and mains. (for 68 427 juice-lifter blocks you block at the front of the block In order for you to utilize a mechanical cam, in your 390, you will need to block the lifter galleries that run parallel on either side of the center oil gallery on the top of the block. You block these galleries off at the rear where they feed from that center gallery. You must plug the feed above and below the left and right lifter oil gallery. This will not impact your oil flow whatsoever. Also you will need pushrods and adjustable rockers in order to use the mechanical cam. Good luck- Dan |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|