|
|
|
|
Original Message
|
| RE: fe valves |
| By giacamo - 11/27/2003 11:46:18 PM; IP 63.163.157.12 |
| hydraulic @ solids should use the same size. the stems may very thay make over size stems with the same size heads on them.insted of installing gides the shop would just ream and install new valves.the thing that,s got me confused is the shorter valves? the only shorter valves i,v sean was on a basterized set of heads wear cheavy b block valves. some one instaled and ripped a buddy of mine off. if the castings has the same ports and cc,s i,d toss the valves&springs and by as a bare set.thease heads you have listed i feal don,t have any thing special going for them over the standerd pre 65 fe heads so i,d by cheap just to have a set of bare castings around..... |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|