|
|
|
|
Original Message
|
| RE: off-topic engine rebuild help jeep |
| By peter - 12/09/2003 10:04:33 PM; IP 67.118.0.37 |
| u may have to just try them and see which gives u a better pattern on the valve tip/ by using a "sharpie" mark top of valve install rocker components and rotate engine several times- scuff mark should be directly center as possible on valve tip/ if mark is on the far side of push rod; push rod too long if mark is closer to push rod; push rod is too short |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|