Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Actually, my purpose is a bit different than some. By Paul Garvin - 01/09/2004 9:24:44 AM; IP 65.105.39.50 Dave, Info for your database. My block is a D4TE with MCC casting marks. It would not take a 16/64th bit anywhere except one spot between cylinders three and four (I think). It would take a 15/64th bit everywhere except the bore spacing on the other side of the one where the 16/64th would fit. Iyt only fit 14/64th in between those bores. It sonic out very well with the smallest side being .110 after a .030 overbore, but one cylinder had to be sleeved because of of pourosity problems. Paul Garvin

This thread, so far...

Skip Navigation Links.  Cyl Wall Thickness Test -- Tim P., 01/08/2004  Here ya go. -- Dave Shoe, 01/08/2004  RE: Here ya go. -- BarryMcLarty, 01/08/2004  It'd work, but I prefer drill bits. -- Dave Shoe, 01/08/2004  RE: Here ya go. -- Tim P., 01/08/2004  RE: Here ya go. -- BarryMcLarty, 01/08/2004  Actually, my purpose is a bit different than some. -- Dave Shoe, 01/08/2004 RE: Actually, my purpose is a bit different than some. -- Paul Garvin, 01/09/2004  Wall thickness -- Steve M, 01/12/2004  RE: Actually, my purpose is a bit different than some. -- bear, 01/17/2004  Here are a couple of references. -- Dave Shoe, 01/27/2004  RE: Here ya go. -- Tim P., 01/26/2004  RE: Here ya go. -- Tim P., 01/29/2004  Sounds like a nice block. -- Dave Shoe, 01/29/2004  RE: Sounds like a nice block. -- Tim P., 01/29/2004  The "X" remains a mystery. -- Dave Shoe, 01/30/2004  RE: The "X" remains a mystery. -- Tim P., 01/30/2004

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024154444 in the box