Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Be careful using casting information By chris - 01/20/2004 11:54:50 AM; IP 68.70.78.49 Thanks Royce. That should be helpful. So does this mean that there could be a 390 or 360 with the side oiler galley that was cast from a 427 s/o mold? Is the cylinder wall thinckness something that a machine shop can measure? Thanks in advance for your time and assistance.

This thread, so far...

Skip Navigation Links.  427 fe block id -- chris, 01/20/2004  Be careful using casting information -- Royce P, 01/20/2004 RE: Be careful using casting information -- chris, 01/20/2004  Search "drill bit test" -- Royce P, 01/20/2004  The "figure-8" boss is only on the rear. -- Dave Shoe, 01/21/2004

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202417411 in the box