Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

428 engine By Don - 01/31/2004 10:54:12 AM; IP 24.71.148.102 Building a 67 428 engine was wondering if C6AE rods were ok? and the heads i was going to use are drilled (4 holes) casting number C6AE 8090R, i am going to be using Aires 11-1 30 0ver pistons,and i have 209-165 ss valves.Is this a good combo??

This thread, so far...

Skip Navigation Links. 428 engine -- Don, 01/31/2004  Good mix. -- Dave Shoe, 01/31/2004  RE: 428 engine -- Don, 01/31/2004  Crane 282S. -- Dave Shoe, 01/31/2004  RE: Crane or Comp 282S? -- McQ, 01/31/2004  Comp, not Crane. -- Dave Shoe, 01/31/2004  I used a Comp 282S in my most recent motor. -- Royce, 01/31/2004  RE: I used a Comp 282S in my most recent motor. -- Tim P., 01/31/2004  I think attention to detail is important. -- Royce Peterson, 02/01/2004  RE: I think attention to detail is important. -- Tim P., 02/01/2004  Blueprinting terms -- Royce, 02/01/2004  RE: Blueprinting terms -- Tim P., 02/01/2004  RE: Blueprinting terms -- Tim P., 02/02/2004  Guides -- Royce, 02/02/2004  RE: Guides -- Tim P., 02/03/2004

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024171829 in the box