Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

hydraulic or solid cam? By Ian Dobson - 02/06/2004 5:12:18 AM; IP 24.84.238.236 Here's the scenario I drive my car less than 10,000 miles a year, probably more like 5000 I do take it out to the track a lot too. I'm in 2 minds weather to get the CC DEH275 or the CC 282S. the engine is as follows, a 428 FPA headers and edlebrock heads and performer RPM intake, carb is a 750 dbl pump, 4 speed in a 69 mustang. I did have the performer RPM cam, but I returned it after peer pressure from this forum :) If I go the solid cam route, where can I get my hads on the instructions to change the block for a solid cam, I think I understand what has to be done, but I'd rather see how to do it properly.

This thread, so far...

Skip Navigation Links. hydraulic or solid cam? -- Ian Dobson, 02/06/2004  Those cams are very close in performance. -- Royce, 02/06/2004  RE: Those cams are very close in performance. -- Ian Dobson, 02/06/2004  Not much bother really. -- Royce Peterson, 02/06/2004  RE: Not much bother really. -- Ian Dobson, 02/06/2004  I would use the Comp Cams parts. -- Royce, 02/06/2004

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024154821 in the box