|
|
|
|
Original Message
|
| Torque specs. |
| By Dano - 02/20/2004 7:27:15 PM; IP 67.50.230.104 |
| I am going to be using studs for the Edelbrock heads I am putting on my 390. The head side of the stud threads are fine. The block side of the threads are the standard coarse. Does anybody know what the torque should be. Is there a correction factor? I don't want to use the specs out of the book because obviously, with the fine threads being torqued to the coarse standard threads spec. the clamping force on the heads will be much greater than it should be. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|