|
|
|
|
Original Message
|
| RE: oil pump shaft in oil pan |
| By rick - 03/03/2004 3:58:13 PM; IP 65.28.72.17 |
| Been there , I used two magnets to get mine out. Use a bar type (round, solid about 4" long) in the pan and a large one outside. Tie a string to the bar type (make the string wet first) and use the large magnet on a rag to guid the bar magnet to the shaft. Then retreave in reverse. May take some time but you can do it this way. Use the side of the pan on the way to and from the sump. You may try just the large magnet on the outside by itself first. Harbo Freights has the large (150#) for about $7. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|