|
|
|
|
Original Message
|
| Single plane intake modification? |
| By bprewit - 03/06/2004 12:59:12 AM; IP 209.240.162.167 |
There is a trade off between a single plane and dual plane intake....dual plane excellent throttle response and good bottom end though starts to lose on top end. Single plane makes for bad low end and slower throttle response but makes good horsepower in higher rpm's. Ok this is what I was told and taught so if im wrong somebody correct me. Anyways I was wondering if a single plane intake could be made to use a divider plate. A divider could be made to different lengths to tune a engine differently I am guessing by reducing or enlarging the plenum size. Anyone tried this before? I know its not going to be the best of both worlds but maybe could make slightly better low end without sacrificing much top end? Just an idea and curious if anyone has tried it before?
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|