|
|
|
|
Original Message
|
| Easy oil restrictor fix ! |
| By Jay - 05/16/2004 10:28:36 AM; IP 207.69.139.8 |
| I had contemplating this awhile. I had an old set of heads in the attic that I got down and noticed that the oil hole in the head under the rocker stand is about 5/16. A 3/8 16 tap calls for a drill bit of 5/16. So, I just ran the tap in the oil hole. Had a couple of set screws in 3/8 16 and just screwed them down into the threaded hole. I tapped the whole just deep enough so that the set screws were just below the top of the whole. Drill the center of the set screw out to your liking and your done. I'm sure this has been before but just thought this was a real easy, neat little way of doing it. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|