|
|
|
|
Original Message
|
| Installing 390 in a 1969 Mustang. Any tips?? |
| By Dano - 05/25/2004 10:43:44 PM; IP 67.50.229.35 |
The 390 for my 69 Mustang is about ready to install. I was wondering if anyone had any recommendations on the best way to put it in. I am planning on putting the flywheel, clutch and bellhousing on first, making sure the transmission goes in ok . Then dropping the engine, bellhousing, clutch assembly in with the FPA headers on, bolt it to the motormounts and then put the transmission in from underneath. Would it be easier to put the engine, with headers, and transmission allready on, into the car allready assembled?
[Title edited for clarity by Admin.] |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|