|
|
|
|
Original Message
|
| RE: converting hydraulic block to solids |
| By cuzncletus - 06/14/2004 11:04:03 PM; IP 68.220.56.119 |
| There's obviously a hung jury on the issue of plugging the lifter galley. Here's all I can tell you about restrictors on Edelbrock heads; spinning the oil pump with a speedwrench by hand produces what appears to be plenty of oil, especially for roller rockers. With an HVLP pump the rockers are drenched and dripping in seconds. This is using a Holley .087 jet (sold by the camgrinder as a "restrictor") in the heads. I can only imagine what it would look like at RPM's. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|