|
|
|
|
Original Message
|
| RE: 390 Mach 1 problems |
| By Tony P. - 06/19/2004 10:59:11 PM; IP 68.15.59.197 |
| Scott, a common problem when using HV oil pump is flooding the heads with oil and sucking it down the guides, put an old holley main jet anysize from#75- 90 in the oil feed under the rocker stand. This will supply more than an adequate oil flow to the rockers. Also check to make the return passages are clear and a glob of silicone or gasket sealer is not obstructing the flow. You mentioned fel pro intake gaskets, there have been some problems with the print o seal fel pros failing and sucking in oil. Look at the post below by Salid on 6/16, it shows a picture of a sucked in fel pro.: http://www.jcoconsulting.com/forumfe/reply.aspx?ID=21843&Reply=21843 |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|