|
|
|
|
Original Message
|
| RE: fender emblems |
| By bubba - 08/25/2004 9:06:52 AM; IP 69.149.33.130 |
| If its been painted dig it out. If its aftermarket emblem (chinese) use a needle file and gently file diameter down slightly. Lastly, if its orig. from same nuts, tap in with rubber mallet. You cam remove bottom rear fender bolt/shim and use your hand for rear bracing. Good luck. As a side note it would'nt hurt to dap a small amount of adhesive to back of emblem. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|