|
|
|
|
Original Message
|
| RE: What FE engine do I have? |
| By giacamo - 11/23/2004 7:05:59 PM; IP 63.163.157.80 |
| the 391 crank snout can be turned down to the standerd 390 size but indexing the keyway is a real bitgh to get right , and the flywheal flange hasted to be thined to the 390 size and a bushing made for the pilot shaft or tork converter and the fliywheal hast to be balanced i had one done and for the money i feal it,s not worth the hassel,the cast crank i feal gives you just as good service,if i was to gess i,d say you have a 1974 pickup block with a 1962 intake and pre 60 heads, problie a rebild and up graded to the newer block to get away from the older block to be abel to use the newer cam setup wich i prefor but this is just gessing without looking inside. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|