|
|
|
|
Original Message
|
| 390GT Exhaust Installation Parts... |
| By richard - 12/22/2004 10:53:29 PM; IP 210.49.45.37 |
Getting ready to reinstall the exhaust system. 68 390GT. At the manifold to H pipe there is a solid cast metal "spacer" about 1 1/2" thick (I think it replaces a flapper type valve).
The spacer is flat on one side and dished on the other. There is a solid metal donut to go between the H pipe and spacer on the dished side, is this corect? What goes between the flat of the spacer and the manifold face? Special gasket? On the other side of the H pipe there is a mesh/asbsetosy looking donut, quite different to the one at the spacer.
My only reference (the NPD catalog) says the metal ring at both sides. Will this seal properly, or require a bit of finesse to reuse and get a good seal? Are both supposed to be the metal ring or the mesh/asbestosy type??
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|