|
|
|
|
Original Message
|
| RE: 390 Stroker Kits |
| By Dano - 02/16/2005 6:22:16 PM; IP 67.50.228.86 |
| The Scat kits for other Ford engines are very good in my experience, I didn't know they had a stroker kit for the FE series. If you want 550 hp a stroker may not be the way to go since you will need a lot of rpm to get that hp out of the FE. The FE's strong suit is torque which will help you get that big car moving. The oiling modifications are talked about here often, unfortunatly I am no expert on that, I would do a search and you should find what you need. I recently built up a 420hp 390 and the oiling system was totally stock, the only change I needed to make was to install holley jets into the rocker shaft oil feed holes in the heads because of too much oil being sent up to the Erson roller rocker shafts I used. Otherwise the stock pump and passages work fine in my application. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|