|
|
|
|
Original Message
|
| building a 360 into a 390 GT |
| By Paul G. - 03/02/2005 9:07:47 PM; IP 206.147.20.36 |
| I am going to be starting on rebuilding an engine for my 71 Ranger XLT that I am restoreing. I have a stock original 71 360 block. I am going to check were and bore if needed. I have a fresh 390 GT crank and 67 S code 390 GT heads and 428 rods with floating pins and a 390 GT intake. I am on kind of a budget but looking for ideas of cam and pistons that i should use. also a good carb setup. I am just looking for a fun street show truck, may pull a trailer once in a while with it. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|