|
|
|
|
Original Message
|
| RE: 390 piston rings |
| By Dusty - 03/13/2005 12:01:04 AM; IP 68.211.98.196 |
| hey thanks for actually replying. i've been trying to get a hold of them but it seems like everytime i call they are closed. just have to keep trying. oh and my pistons are stamped .040 same as it was bored. when i checked the gap on the piston to bore clearance i don't remeber what it was but it was just in the minimum space after i honed it so my pistons are a little tight. don't know if that matters or not becuause the ring is, as i'm sure you know, measured against the piston wall. thanks for the reply. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|