|
|
|
|
Original Message
|
| more axel information requested |
| By Paul Davis - 08/18/2000 6:06:10 AM; IP 209.142.18.235 |
I have had lots of great imput from all on my axel questions for my FE. I am still a little fuzzy on a few issues. I know I have probably already read over the answer from you and did not get it. Please summerize the the answers to the questions that I am still fuzzy on. 1. It appears to me that 31 spline axels are easy to identify by looking at the outer end of axel (behind hubcap). Is that correct? 2. 31 spline axels will fit some original (from factory) 28 spline axel housings depending on bearing ID size of 28 spline housing. Is that correct? What is the OD size of the 31 spline axel? I will need it when I pull my 28 spline axel to measure my bearing ID to see if it is large enough for the OD of 31 spline axel. Sorry, I know these are probably dumb questions that may have already been answered. Thank you Paul Davis
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|