|
|
Original Message
|
RE: top loader tranny |
By Tony P. - 05/28/2006 10:11:08 AM; IP 68.15.59.197 |
Cheech, before you go pulling the tranny, on the hurst shifter there is a thin sheet metal inspection cover on the bottom of the shifter body, it is held in by tabs on each end. Just pry it off and check the two roll pins that center the shifter handle fork on the main shifter cross shaft. Chances are that one of the pins is bent or broken. Just drive it out with a punch and install some new ones and try that. |
|
This thread, so far...
|
|
Post A Response
|
|
|
|