Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: You can't deck it that far By Royce P - 06/19/2006 12:39:29 PM; IP 216.196.172.47 Forged cranks are heavier. In the case of the one you have it was intended to allow a big heavy truck to lug along wide open throttle at 5000 RPM with a heavy load. A high performance forged crank would be much lighter so that acceleration would be better. For your uses I think a good cast iron crank is best. Cast cranks are light and reliable. I posted a link to the best place to get a new one above. Royce

This thread, so far...

Skip Navigation Links.  deck milling limts for 428 block -- Jonathan Eppstein, 06/18/2006  You can't deck it that far -- Royce P, 06/18/2006  RE: You can't deck it that far -- Chris Shomaker, 06/19/2006  RE: You can't deck it that far -- Jonathan Eppstein, 06/19/2006 RE: You can't deck it that far -- Royce P, 06/19/2006

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202412921 in the box