|
|
|
|
Original Message
|
| Transmission mount |
| By T1M - 01/01/2001 2:57:10 PM; IP 129.105.186.99 |
I have a 68' Galaxie with a 390 2V and a C6. The C6 was from a thunderbird. The previous tranny was an FMX. I had a shop swap the tranny for me.
I just replaced the motor mounts and was told it's a good rule of thumb to replace all the mounts, but it appears that the new tranny mount I bought doesn't quite line up with the trannys bolt holes at the tail. All I can figure is that the garage that swapped the C6 on for me had the same problem and bent the old mount forward the fraction of an inch to line up correctly. I'm trying to bend the mount myself but am not sure I'm doing it right or destroying my new mount. And furthermore, it's just a piece of rubber and metal, would it really hurt to just use the old one a little longer so that I can continue working on other things until I figure out how to bend the new mount? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|