|
|
|
|
Original Message
|
| RE: 390 FE Electronic Ignition Conversion |
| By richard - 06/15/2001 4:20:46 AM; IP 204.111.53.71 |
ok you have two factory conectors one with two prongs and one with four prongs. the two prong connector is the power in. you can hook that one up two ways.
1: tie the red and white wires together and splice them in to the power wire coming from the ignition switch to the coil +. the green wire from the 4 prong connector goes to the coil -.
2: run a wire from the ing side of the starter solenoid to the white wire, and take the wire that you removed from the ing stud and connect it to one of the red wires on the tow prong connector. everything else hooks up the same way. hope this helps. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|