|
|
|
|
Original Message
|
| RE: hugger headers |
| By Will - 07/23/2001 10:46:55 PM; IP 24.162.191.90 |
| Hey - I had always wondered about the long cast iron headers fitting a unibody. Whenever I go down that road, I figure the FPA's are new, they fit, they are about the same cost, and they're lots prettier, so I've never asked anyone if the cast iron jobbies will fit. The short cast iron manifolds don't look like they'll even come close. Thanks for clearing that up for me. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|