|
|
Original Message
|
RE: 428 flywheel does have a balance weight cast in. |
By Jamie Marchesano - 09/16/2001 12:54:06 PM; IP 12.149.182.43 |
Thank You All again for the input. Royce the car has a 4 speed so as Ed suggested I looked for the part number on the fly wheel. I ended up pulling the transmission etc. and there were no numbers anywhere on the flywheel. At this point Royce I went ahead and dropped the pan to confirm the crank was correct. On counterweight #7the code IU which as I understand it is the correct code for a 428cj crank. It also does not have the LeMans capscrew rods but the stock rods for a CJ Motor. Mel that eliminates the possibility of this being an SCJ and needing the balancer and counter weight required. Ed do you have any other way I can verify the flywheel is correct? Everything is indicating to me that I will need to pull the motor and have it rebalanced. Any other thoughts? |
|
This thread, so far...
|
|
Post A Response
|
|
|
|