|
|
|
|
Original Message
|
| Gonna need a lot of help. |
| By Greg Gilliam - 09/22/2001 4:29:12 PM; IP 24.252.182.5 |
O.k. I've determined that the engine I have is a '66 428 "Q" (built in november of '65) The bottom end has never been apart, but the top end has (fel-pro gaskets).
What I don't know is if someone changed the heads, maybe someone here can help. The casting #'s on the heads are C6AE-J with DIF on both, under the DIF one has an E and the other head has a D, next to the c6ae-j is the number 9 on one and a 10 on the other.
Are these good heads? I was planning on using the edelbrock aluminum, but wasn't going to throw the stockers away anyway. Could someone tell me about these?
Thanks
Greg
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|